Examine This Report on cfe pistol for 9mm

Examine This Report on cfe pistol for 9mm

Blog Article

Making use of these circumstances Using the accompanying data will adjust velocities (ordinarily slower) and pressures. Starline scenarios with large pistol primer pockets had been used completely While using the accompanying data.

Usually I am not inclined to drive plated bullets towards the upper reaches of printed data. I believe that if you buy 9mm in bulk jacketed bullets are very near to the price of plated

two-four.3g with 124gr jhp loaded to max duration for my chamber.  My load is "snappy" and accuracy started out showing up in the "snappy" level. Exactly the same charge is accurate and tender with 115gr bullets.

This is certainly an more mature thread, you may not get a reaction, and will be reviving an old thread. You should contemplate creating a new thread.

That is an older thread, you might not get a response, and will be reviving an outdated thread. Remember to take into consideration creating a new thread.

Keep in mind that this was a small sample of only 10 rounds for every load, and for something this imprecise a larger sample would be required for more significant evidence. As a result the primer readings ought to be viewed as "suggestive" rather than conclusive by any indicates.

The truth is, AutoComp's effectiveness with this particular bullet was two fps more quickly than it developed in the 10mm. It's evidence that It really is challenging to predict what actual velocity you will get until eventually you are trying it. The a hundred and eighty-grain speeds with both powders have been simply a bit about one,000 fps.

Tricks for loading plated bullets involve making sure that the situation mouth is flared ample to just accept bullets without harming the comparatively slim copper plating, after which taper crimp them, staying sure to not crimp over and above the .470-inch specification.

This is often an older thread, you might not get a reaction, and could be reviving an previous thread. Be sure to think about developing a new thread.

I do Consider the CFE Might melt away a check here tad cleaner but that’s just speculation on my element. here It seems CFE has a little bit better prices of powder and marginally larger FPS. But near adequate to not really make a variance.

Some guns might exhibit excessive stress signals with CFE (or AC) right before the specified power element is reached. In cases like this slower gunpowder should be made use of because it is commonly the case that slower gunpowder will deliver the exact same velocity but at reduced strain.

The lighter bullet develops additional combustion Place more rapidly. Therefore if we've been to push it to exactly the same velocity, then we need a lot more powder in the beginning to take action.

In case you are just learning ways to reload 9MM, you do not want this powder, as you could unintentionally place an excessive amount of inside a circumstance and go much over and above ebook suggested pressures

I don't load any of my ammo as puff loads. I load what ever is considered the most precise from my gun and The remainder is up to me. I wouldn't carry decreased loads for defending myself, so I see no cause to practice that way. Simply click to expand...